 | | Memory Space
|
|
Hi all, My name is Marcelo Manjon, and i've just finished my 1st. version of my Micromouse Robot. However, since it had some aligment problems, i've decided to use more 12 IR sensors, in order to help the robot to stay aligned along the maze and, (...) (27 years ago, 24-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: MIDI interface
|
|
Craig Try (URL) for MIDI interface and C code for the HB. jss. (...) (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: MIDI interface
|
|
Craig, check the Handy Board main page for Colby Leider's MIDI libraries: (URL) Wheeler Boeing 316-526-5245 daniel.h.wheeler@boeing.com (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Extend memory to 64K.
|
|
All, Anyone extended the handyboards memory to 64K, and what is the best way to do it? Tim North tim.north@symbios.com (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | MIDI interface
|
|
I have some students in a project lab who are trying to interface the keyboard of a 100 year old pipe organ keyboard through a handyboard to MIDI equipment. Does anyone know of a source of information on MIDI packets, c or machine code for creating (...) (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Handyboard construction problems
|
|
Jonathan: Recently had the same problem myself. One of my colleagues passed on a little utility he wrote ( load68hc11 ) which set my config register just fine. I could then use HBDL for uploading programs. I sent the loadhc11 to fredm for him to (...) (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Handyboard construction problems
|
|
I am in the process of assembling a Handyboard. All had gone well until I got to the stage where you download the code to the HB for the first time. This is before the memory is installed. I used HBDL to download with the register set to 0x0c. I got (...) (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | RC motor connection
|
|
Hi, Did anyone know how to connect commercial electronic speed controllers to HB for powering high-current RC (20A to 100A) motors? Billy Kwong (27 years ago, 22-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Rob Gaunts Last Message
|
|
Whoa, i just realized that the instructions *are* correct. Here's why. For this voltage test, the instructions assume you are powering your board from the DC adapter. This should give the 15 volts mentioned, unless: * you hooked up the battery pack (...) (27 years ago, 22-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Rob Gaunts Last Message
|
|
(...) the instructions are wrong -- you should be seeing about 9v, which is the voltage on the nicad pack. i will revise the instructions. thanks for pointing out the problem. fred (27 years ago, 22-Oct-97, to lugnet.robotics.handyboard)
|
