 | | Re: Handyboard construction problems
|
|
Jonathan: Recently had the same problem myself. One of my colleagues passed on a little utility he wrote ( load68hc11 ) which set my config register just fine. I could then use HBDL for uploading programs. I sent the loadhc11 to fredm for him to (...) (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Handyboard construction problems
|
|
I am in the process of assembling a Handyboard. All had gone well until I got to the stage where you download the code to the HB for the first time. This is before the memory is installed. I used HBDL to download with the register set to 0x0c. I got (...) (27 years ago, 23-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | RC motor connection
|
|
Hi, Did anyone know how to connect commercial electronic speed controllers to HB for powering high-current RC (20A to 100A) motors? Billy Kwong (27 years ago, 22-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Rob Gaunts Last Message
|
|
Whoa, i just realized that the instructions *are* correct. Here's why. For this voltage test, the instructions assume you are powering your board from the DC adapter. This should give the 15 volts mentioned, unless: * you hooked up the battery pack (...) (27 years ago, 22-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Rob Gaunts Last Message
|
|
(...) the instructions are wrong -- you should be seeing about 9v, which is the voltage on the nicad pack. i will revise the instructions. thanks for pointing out the problem. fred (27 years ago, 22-Oct-97, to lugnet.robotics.handyboard)
|
