|
|
 | | Strange HB problems
|
| Over the past two days I have had two problems with my HB that I can't explain. Maybe you you can help. 1. I wrote a simple program to test out my motors that consists of the motor, sleep, and beep commands. Once in a while I get an error back while (...) (27 years ago, 19-May-97, to lugnet.robotics.handyboard)
| | | | | (no subject)
|
| Another note on soldering.. Heat control is VERY important.. Not so much being able to adjust the heat, as having a temperature-controlled iron. The "cheaper" irons get hotter or colder with the load (speed of soldering) as well as the room (...) (27 years ago, 19-May-97, to lugnet.robotics.handyboard)
| | | | | Re: Soldering (fwd)
|
| Often novices miss the single most fundamental point about soldering: you don't use the iron to melt the solder (99% of the time) -- you heat the component leads and let them melt the solder. To initially transfer heat effectively to the leads, a (...) (27 years ago, 18-May-97, to lugnet.robotics.handyboard)
| | | | | Re: Soldering
|
| (...) experience >at all with soldering. (...) become more >adept at this sort of stuff. And what type of solder should I use? Shane is right, you'll find using very thin solder works much better. Along with a fine tip, you'll want to use a low (...) (27 years ago, 18-May-97, to lugnet.robotics.handyboard)
| | | | | Soldering/ Second processor
|
| ->Hi, I'm planning to purchase the handyboard as a kit from Digital Mirco System, since I'm a bit tight with money. However, I'm a bit hesitant (...) soldering. The trick is to use THIN 60/40 solder with flux core. Around 0.71 mm thickness is good. (...) (27 years ago, 17-May-97, to lugnet.robotics.handyboard)
|
|
