|
|
 | | Re: running .s19
|
| shouldn't you be going into expanded mode, not single chip? (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: running .s19
|
| does your program to anything else other than attempt to leave special mode? You could have it write a value to the motor address ($7000); that would be a more visible indication that it is running. BTW, why is your first instinct to take it out of (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | running .s19
|
| Hello, I am trying to use normal .asm files assembled with as11 on the handy-board. I am not using IC. Although my .s19 file downloads fine I don't think it is being run. My code begins at $D000. I use an ORG statement to set $BFFE:$BFFE to $D000. (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: Polaroid Sonar
|
| Sriram, (...) It is on the outer edge of the module neer the ribbon cable connector. Its exact location is indicated by a circle with a + sign to indicate the polarity. (...) I simply (temporary) soldered to the connector at the end of the ribbon (...) (28 years ago, 18-Feb-97, to lugnet.robotics.handyboard)
| | | | | reset vector
|
| (...) Since the Handyboard runs in "special test mode", the vectors are in the $BFxx page. Therefore, you'd want to use $BFFE:$BFFF. -- Randy ---...--- Randy Sargent Newton Research Labs Senior Design Engineer Robotic Systems and Software (...) (28 years ago, 18-Feb-97, to lugnet.robotics.handyboard)
|
|
