 | | (no subject)
|
|
Please add me to the mailing list. Thanks. (28 years ago, 3-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Re[2]: Config 0C / 0D
|
|
Ed, Yes, I got round the problem by using the Newton labs IC 3.1 Beta, which does all the downloading itself. After a couple of tries, it told me that it had reset the config register. I never managed to change it with hbdl, and now I only use IC (...) (28 years ago, 3-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Hi folks a question about ic.
|
|
(...) In regular C, you just ask for what you want by declaring the convert in a statement like... Knob_value = knob(); How_much = float(knob_value); servo_deg(How_much); or save a variable with... Knob_value = knob; servo_deg(float(Knob_value)); (...) (28 years ago, 2-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Nevermind about that int to float question.
|
|
Duh- sorry I just realized that you just typecase the variable however you want it to be. Anyway- visit my hardware hacks page for a laugh if you have time. -Ira (28 years ago, 1-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Hi folks a question about ic.
|
|
Hi, is there some kind of integer to float call in ic? I am trying to write a test servo routine that takes the knob() value and turns the servo to that number of degrees using servo_deg() which takes a float. Any ideas? My board was just recenly (...) (28 years ago, 1-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Display
|
|
Hi- I'd like to separate my display from my handyboard and wire it via ribbon wire so I can view it remotely. Can I do this? How far away can I have the display from the board until it is unable to fully transmit a signal? Thanks, Mike Degon (28 years ago, 31-Jan-97, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
Hi .. I want to unsubscribe temporary, because I want to turn off my computer in several weeks. Thankyou very much. (28 years ago, 30-Jan-97, to lugnet.robotics.handyboard)
|
| |
| | Rating DC motors
|
|
I've got this old Radio Shack RC car that I want to use as a chassis for the HB I'm building. It is the same type car that the Mobot Lab used to build Tom and Jerry. I no longer have the box and I ripped the RC board out of it long ago. How can I (...) (28 years ago, 30-Jan-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Buncha bouncebacks
|
|
Sorry, there is nothing I can do about this short of compiling, installing, and configuring brand new mail list software from scratch. The mail list SW my lab provides is very primitive and can't do anything intelligent with bounces. I don't really (...) (28 years ago, 30-Jan-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Is 18V correct?
|
|
For the HB, when do you draw 500mA? When you put the interface on "Zap Charge", do you lower the voltage less that 12V? What about when you "trickle" it? Hihger that 12V? (...) (28 years ago, 29-Jan-97, to lugnet.robotics.handyboard)
|
