 | | Re: 4WD 4WS model w/limited slip diff. NOTE
|
|
PS. THe nice looking photos of the lego elements were cropped from originals found on the Technic Elements Registry: (URL) basically describe the key elements necessary to complete the model. (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
|
| |
 | | Re: 4WD 4WS model w/limited slip diff.
|
|
This photo might help (2 URLs) the rubber-band connection between the two power outputs, whenever the model would go over a bump and one wheel was lifted off the ground, the other wheel would not spin at all and all the power went to the other (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
|
| |
 | | Re: On 9V battery box #5391 for projects
|
|
(...) DOH! (URL) FRIDAY!!! (28 years ago, 9-Apr-99, to lugnet.robotics)
|
| |
 | | On 9V battery box #5391 for projects
|
|
I recently got a 5391 9V battery box from S@H to put my RCX IRPD board into. I cut off all but 3 nubs worth of the box from the end with the switch and removed the battery tensioner at that back. The board fits in nicely with just the LEDs sticking (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Even more remote controls
|
|
(...) Since you can control the IR LED directly you should be able to get this all working in SW. You will need to modulate the IR with a 40Khz carrier. From there you then turn on and off the carrier to create the start, data and stop bits. This is (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
|