 | | Re: multi-device output controller
|
|
Right. That is why you cannot use all 8 power levels. The polarity reversal that I am talking about is on the controlling (and only) output. I am already assuming, at this point, that drive power is stuck on as with your external battery box. (...) (28 years ago, 26-Mar-99, to lugnet.robotics)
|
| |
 | | Re: multi-device output controller
|
|
(...) I don't know how NQC drives the ports, but both rcxcc and the RIS software have separate controls for on/off and power level. I just tested setting all 8 power settings - motors operates for all 8. -Wes (28 years ago, 26-Mar-99, to lugnet.robotics)
|
| |
 | | Re: Stepper motor design
|
|
(...) It realy depends on what form of stepper motor you are using and how the coils are wired up. if you can arange it as two sets of coils you could drive it by hooking one motor output up to one pair of coils and the second motor output up to the (...) (28 years ago, 26-Mar-99, to lugnet.robotics)
|
| |
 | | Re: multi-device output controller
|
|
Thanks for checking this out. This is important to know. I assume, then, that the duty cycles are 1/8 through 8/8 as well as off, which would be 0/8. Can anybody verify this (with a scope or something)? I have long wondered whether the duty cycles (...) (28 years ago, 26-Mar-99, to lugnet.robotics)
|
| |
 | | Re: multi-device output controller (fwd)
|
|
How about an RCX to RS232 connection to use off the shelf components? Check out this link. (URL) sells a simple serial servo contol that services up to 8 motors via an rs232 port ($49.95). I have seen a simple version adapted for a Palm Pilot for (...) (28 years ago, 26-Mar-99, to lugnet.robotics)
|