Subject:
|
Re: Sensors via VCR
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 15 Feb 1999 16:34:48 GMT
|
Original-From:
|
Joel Shafer <JOEL@CONNECTihatespam.NET>
|
Viewed:
|
3260 times
|
| |
|
|
Don't forget the motor from the VCR. I'm using my old VCR's motor to power
the grabber-claw of my robot.
At 09:40 PM 2/14/99 -0500, Bill Leggett wrote:
> The best source I can think of is the old family VCR. It has MANY momentary
> switches and probably 5 or more LED's in the front panel. There are two
> infra-red
> photosensors and a two sided infra-red LED on a post in the tape drive area.
> Good
> Luck! :->
>
> The Clark Family wrote:
>
> > I am gathering parts to make sensors and was wondering if anyone
> > has a good source for small microswitches ( for tuch sensors) and
> > also LED lights 9 to 12 volt.
> >
> > Thanks in Advance
> >
> > Jim Clark
> >
> >
> ------------------------------------------------------------------------------
> > This message was sent from Bess.Net, a filtered Internet Access Provider
> > for children and families.
>
> ------------------------------------------------------------------------------
> >
> > --
> > Did you check the web site first?: http://www.crynwr.com/lego-robotics
>
> --
> Did you check the web site first?: http://www.crynwr.com/lego-robotics
Joel Shafer joel@connect.net
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message is in Reply To:
 | | Sensors
|
| I am gathering parts to make sensors and was wondering if anyone has a good source for small microswitches ( for tuch sensors) and also LED lights 9 to 12 volt. Thanks in Advance Jim Clark ---...--- This message was sent from Bess.Net, a filtered (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|
10 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
