 | | Re: Synchro Drive
|
|
(...) Drive" <SNIP> (...) <SNIP> I built my first Synchro Drive platform last night and have, of course, encountered the same problem. I, too, toyed fruitlessly with hideously complex gear trains with differentials, trying to accomodate the odd gear (...) (28 years ago, 5-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Angle Sensor; 1999 Catalog
|
|
(...) Has this been everyone's experience? I have not had the chance to experiment with my angle sensors very much since I got them, but by hooking one up to the RCX and VIEWing the sensor reading (sensor set to angle via Command Center), it (...) (28 years ago, 5-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Angle Sensor; 1999 Catalog
|
|
(...) I am using two angle sensors in my synchro drive bot and both are rotating at mini motor full speed. There have been times where it seemed to drop a few counts ( approx. 1% ) but I have yet to verify this. I only noticed this because after (...) (28 years ago, 5-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Alternate C compiler for LegOS
|
|
=>From: "Gavin Smyth" <gavin@beeskneesDOTf...OTcoDOTuk> =>... =>Alternatively, have a look at (URL) =>where I've done a similar but lazier job of just providing an add-on lump to =>Cygwin (ie, you need Cygwin first). I have to confess I haven't (...) (28 years ago, 5-Feb-99, to lugnet.robotics)
|
| |
 | | Re: gearing problem, continued
|
|
=>From: "John A. Tamplin" <jat@Traveller.COM> =>... =>Yes Ncm is a unit of torque, Newton-centimeters. However, I have no idea =>quantitatively how much torque that is since I haven't ever measured the =>output of the Lego motors. Have you ever had (...) (28 years ago, 5-Feb-99, to lugnet.robotics)
|