 | | Re: Help! Can't talk to IR Tower with Mac w/nqcc!
|
|
(...) That wiring looks fine, provided that "IR" is a DB-9 female that connects directly to the IR device. If you use the IR cable supplied by lego, then you'll need to swap pins 2 and 3. Mac pins 1 and 2 (RS-232 pins 7 and 8) are not required at (...) (28 years ago, 21-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Direction of rotation sensor.
|
|
(...) Here's a thought: A rubber band around the axle to check and a pulley with a peg in it. In one direction, the pulley/peg run into the touch sensor and the band then starts slipping on the axle (hopefully geared down enough to sufficiently push (...) (28 years ago, 21-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Homebrew Rotation Sensor
|
|
I've added a circuit diagram for something that comes close to making voltages that look like a real LEGO Rotation Sensor. It's not perfect yet. The RCX may loose a few counts here and there. I think I need a better Opamp than the old LM324. (URL) (28 years ago, 21-Jan-99, to lugnet.robotics)
|
| |
 | | Any interest in an RCX simulator?
|
|
I have been considering working on an RCX simulator for use with NQC programs. I'd be willing to develop the core simulator itself if others were willing to do the user interface work. I'll make sure the simulator is as portable as NQC currently is (...) (28 years ago, 21-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Help! Can't talk to IR Tower with Mac w/nqcc!
|
|
Success!! On the advice of Ben Kimball I started looking for an extension that might be competing for the serial port. My system is also used for MIDI and I found the MIDI Manager extension. I disabled it and rebooted and found that I could now talk (...) (28 years ago, 21-Jan-99, to lugnet.robotics)
|