Subject:
|
RCX infra red sensitivity
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 16 Jul 2006 16:20:34 GMT
|
Viewed:
|
2778 times
|
| |
|
|
Hello everybody,
One of my RCX units is far less sesitive to recieve a IR signal from another RCX
than the other ones. Can this be adjusted in some way?
Thanks,
Eric.
|
|
Message has 2 Replies:
 | | Re: RCX infra red sensitivity
|
| (...) I think you can adjust the transmit value from the software, but not the reception sensitivity as far as I know. IR sensitivity can be affected by battery performance, ambient lighting (though not likely a factor if others are responding (...) (18 years ago, 17-Jul-06, to lugnet.robotics)
| | | Re: RCX infra red sensitivity
|
| (...) Thanks for your replies. Both are RCX2 and I use the Robolab software. In Administrator / RCX settings you can set the RCX IR-power setting to high or low, but both were already in high. After some testing I found out that the main problem are (...) (18 years ago, 20-Jul-06, to lugnet.robotics)
|
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
