Subject:
|
Re: 3 sensors = 8 inputs?!
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 8 Jan 1999 17:07:18 GMT
|
Original-From:
|
Mark Crosbie <MCROSBIE@CUP.HPstopspammers.COM>
|
Viewed:
|
1283 times
|
| |
|
|
In message <36955C7E.35297C08@ghg.net>, "John A. Donaldson" writes:
> Mark,
> It has been figured out how to get four touch sensors per input. This gives
> 12 touch sensors if all three inputs are used.
Yes, but using a lever based approach gives a "pure Lego" solution to the
problem, which appeals to the Lego purists out there :-)
Me personally, I would use the electronic approach you outlined in your email.
Regards,
Mark.
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message is in Reply To:
 | | Re: 3 sensors = 8 inputs?!
|
| Mark, It has been figured out how to get four touch sensors per input. This gives 12 touch sensors if all three inputs are used. Using this approach, a 16 channel Analog MUX can be hooked up. Sensing the four switch lines using Port A and the Output (...) (25 years ago, 8-Jan-99, to lugnet.robotics)
|
11 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
