Subject:
|
Re: Three cheers for Dave Baum !!! !!! !!!
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 5 Jan 1999 00:59:13 GMT
|
Viewed:
|
1516 times
|
| |
|
|
In article <F525IC.As6@lugnet.com>, "Cyberia" <cyberia@erols.com> wrote:
> Also, the program MUST have the IR tower on COM1 or COM2 (internal ports).
> Any idea why it refuses to work on my Equinox superserial card (COM3,4,5,6)
> ? NQC works quite happily on COM3, but NQCC says it can't find the RCX. I
> had to move my IR tower to COM1 and move the modem to COM3 to get around
> this.
I'm a little confused by the above statement. Does nqcc itself work using
com3? If not, email me and perhaps we can debug it.
Dave
--
reply to: dbaum at enteract dot com
|
|
Message has 1 Reply:
 | | Re: Port problem with RCXCC (and not with nqcc)
|
| Sorry if I was not clear. nqcc works PERFECTLY on COM3 (first channel of the Equinox board). The original Mindstormes software (and the RCXCC software) do NOT work on this port. I was hoping this would be some kind of big clue for Mark (what is (...) (26 years ago, 5-Jan-99, to lugnet.robotics)
|
Message is in Reply To:
| | Re: Three cheers for Dave Baum !!! !!! !!!
|
| Yes. Great stuff Dave and Mark ! We built a tracked robot and find the "remote control" utilizing the joystick (version 2.0 of RCXCC) to be just as cool as programming it to run autonomously. I am amazed at how well the IR tower communicates at all (...) (26 years ago, 4-Jan-99, to lugnet.robotics)
|
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
