Subject:
|
Re: remote control
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 20 May 2002 20:38:17 GMT
|
Original-From:
|
Steve Baker <sjbaker1@airmail.netSTOPSPAM>
|
Reply-To:
|
sjbaker1@!ihatespam!airmail.net
|
Viewed:
|
2332 times
|
| |
|
|
Bob Fay wrote:
>
> The buttons "1", "2" & "3" send a IR message to the RCX. The RCX must be
> running a program that will respond to one or more of those messages.
> The A, B, C buttons will activate the RCX outputs forward or reverse. This
> requires only the installed firmware and the brick in the "on" mode.
> Program buttons 1 through 5 will start any one of the installed programs.
> The "stop" button will end the active program. The button with the speaker
> symbol will cause the RCX to beep. This assures IR contact with the RCX.
It also works with the Scout - except that A & B drive the motors and the
C buttons turn on the red LED. I havn't quite figured out what the P1..P5
buttons do - they evidently activate some of the built-in functionality - but
I can't be bothered to figure it out exactly.
The IR remote is a REALLY useful tool.
----------------------------- Steve Baker -------------------------------
Mail : <sjbaker1@airmail.net> WorkMail: <sjbaker@link.com>
URLs : http://www.sjbaker.org
http://plib.sf.net http://tuxaqfh.sf.net http://tuxkart.sf.net
http://prettypoly.sf.net http://freeglut.sf.net
http://toobular.sf.net http://lodestone.sf.net
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: remote control
|
| The buttons "1", "2" & "3" send a IR message to the RCX. The RCX must be running a program that will respond to one or more of those messages. The A, B, C buttons will activate the RCX outputs forward or reverse. This requires only the installed (...) (24 years ago, 20-May-02, to lugnet.robotics)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
