 | | Re: NQC "No reply from RCX" Help Please —Dave Baum
|
| | | (...) My first guess on this problem is that the firmware is no longer loaded on the RCX. Check the LCD display - if it doesn't show 5 digits (e.g. "00.00 1") then the firmware isn't installed. If you can locate the firmware file (typically called (...) (23 years ago, 20-May-02, to lugnet.robotics)
|
| | | |
| | | | | Re: NQC "No reply from RCX" Help Please —John Hansen
|
| | | | | (...) <snip> (...) The most likely thing I can think of is some program is running that is holding open the USB Tower port. I think Jeff told me via e-mail that he is using the latest release of BricxCC/NQC. A less likely alternative would be a (...) (23 years ago, 20-May-02, to lugnet.robotics)
|
| | | | | |
| | | | | | | Re: NQC "No reply from RCX" Help Please —Jeff McClain
|
| | | | | | (...) I'm about to go ahead and wipe the laptop hard drive and just reinstall WinXP and see if I can get everything working from a clean install. I've done a LOT of things on this lap top and had quite a few USB devices installed... -Jeff McClain (23 years ago, 20-May-02, to lugnet.robotics)
|
| | | | | | |
| | | | | | | | Re: NQC "No reply from RCX" Help Please —Jeff McClain
|
| | | | | | (...) Well, I reinstalled Windows XP and then installed RIS 2.0 and NQC/BRICXCC and everything worked like a dream. I have no idea why it wouldn't work before (did everything the same). Strange that it would work in RIS 2.0 but not in NQC or (...) (23 years ago, 24-May-02, to lugnet.robotics)
|
| | | | | | |
| | | | | Re: NQC "No reply from RCX" Help Please —Jeff McClain
|
| | | | (...) It definately said "could not open serial port" (I typed it in quotes even and copied it directly from the program). The NQC version is the latest off your page (2.4_r2). And I was using the -SUSB (I'll have to go back and double check that I (...) (23 years ago, 20-May-02, to lugnet.robotics)
|
| | | | |
| | | | | | Re: NQC "No reply from RCX" Help Please —Dave Baum
|
| | | | (...) Can you type "nqc" and check to see what version number it prints out? I've double-checked the source code, and it should say "Could not open serial port or USB device". Is it possible there are multiple versions of NQC and your command path (...) (23 years ago, 22-May-02, to lugnet.robotics)
|
| | | | |
| | | | | | Re: NQC "No reply from RCX" Help Please —Jeff McClain
|
| | | | (...) Hum, says: nqc version 2.4 r3 (built Mar 24 2002, 16:32:33) Thought I had r2 for some reason, but it says same thing if I fully path it. (...) (23 years ago, 22-May-02, to lugnet.robotics)
|
| | | | |
