 | | Re: New ROBOLAB pages....
|
|
The IR tower can be used on a MAC using ROBOLAB and a MAC cable for the tower. Pitsco ((URL) sell the MAC cable (bundled with the tower) (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | ROBOLAB in Europe
|
|
Hi all Is somebody outthere aware of a possibility to buy ROBOLAB in Europe (Switzerland to be more specific). I am proud owner of the Mindstorm Robotic package but would like to buy the ROBOLAB software for my Macs too. Thanks for any hint along (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | RE: Batteries?
|
|
(...) How about using rechargeable alkaline batteries? (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | RE: space shuttle technic set cost?
|
|
Yes, 8277 is mostly good for getting lots of long beams in yellow and grey. However, it also contains a good number of "push-pin pegs". These are like the normal black 3-beam friction connector pegs, but with a bushing attached on one end. They come (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Laser pointing devices could cause damage
|
|
(...) Well, I didn't even take that into consideration when I tried it. It worked, and I haven't noticed any change in the performance of my sensor. I'm not exactly sure how the sensor works, but I'm pretty sure it's a CdS photoresistor, so the (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Robot Battery Level
|
|
I'd like to program my robot to beep for attention when the batteries start to wear down, however it appears that only the tower can query the battery voltage. I'd rather not have my computer query the robot and send the battery level back to the (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: flexible tubbing
|
|
(...) I think the Lego tubing is PVC, rather than rubber. Silicone rubber tubing might be more flexible, though I think it will also be heavier. It's most conveniently found in small diameters at model shops, sold as fuel tubing for model aircraft. (...) (28 years ago, 16-Dec-98, to lugnet.robotics)
|
| |
 | | How do I get off this thing??? 8-)
|
|
How do I get out of this list????? /\/\ark Interactive Media Developer rgbStudio, Inc www.rgbstudio.com (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Re: How do I get off this thing??? 8-)
|
|
Mark Streed wrote in message (...) Iif you send an blank email to the address indicated you will be unsubscribed from the list. lego-robotics-unsubs...crynwr.com instructions were found in the third paragraph of this page: (URL) write me if you are (...) (28 years ago, 17-Dec-98, to lugnet.robotics)
|
| |
 | | Now one with my address
|
|
(...) ldsmith@pfc.forestry.ca (28 years ago, 17-Dec-98, to lugnet.robotics)
|