 | | Re: Struggling with encoder wheel
|
|
(...) You could make a big wheel made of lego plates, and put smooth ones on top for 'colors'. Then you could use a touch sensor, and use the difference between the low spots and the high spots as 1 location. Do you really need to know the direction (...) (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Re: Looking for orthogonal motion
|
|
Hi David, I have built a robot that does this for a university 'robot maze solver' project. My solution is big, ugly, very slow and pretty complex. It could probably be improved a lot if it was redesigned. However, it uses 3 motors (1 for (...) (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Re: Struggling with encoder wheel
|
|
(...) I was wondering how you were handling the edge conditions. Have you tried making a wheel which is a continuous gradiant from black to white over the 360 degrees of rotation? Lookup wouldn't be required as there would be a direct relationship (...) (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Re: Pneumatic Pump Testing Goes Hi Tech
|
|
(...) My answear to that is of course unprintable (although it starts with 'P' and ends with 'off') :-) ha ha ha... Steve (24 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Problems with the scout
|
|
I downloaded the program from RCX Command Centre to my scout. I then pressed run, but it didn't run the program. It wasn't to big because it was it was only 'On(OUT_A);'. Does anybody know what to do? TNX (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Re: 2.0 Firmware
|
|
In article <GBn3FD.Cw5@lugnet.com>, Dean Hystad <dean.hystad@mts.com> writes (...) What and where would the 'DLL' path be?? (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Re: Amiga Software
|
|
(...) ... in the US. It was HUGE in Europe, esp. UK and Germany. -Simon (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Re: 2.0 Firmware
|
|
(...) The DLL path is the directory that the *.dll files are located (dll standing for Dynamic Linked Library). You probably unzipped all the files into one directory. If this is the case then all the paths should be to that directory. Make sure (...) (24 years ago, 12-Apr-01, to lugnet.robotics)
|
| |
| | Internet Controlled Robots
|
|
I am wanting to begin experimenting with web based control of the RCX using RoboLAB 2.0 but have not been able to find any information. Can anyone kindly lead to some resources? I have only the knowledge that this can be done, nothing else. (24 years ago, 12-Apr-01, to lugnet.robotics.rcx.robolab, lugnet.robotics.edu, lugnet.robotics)
|
| |
| | Re: Struggling with encoder wheel
|
|
Chris, This idea would require an additional motor, but, an alternate approach might be to create your wheel with 36 alternating grey and white (perhaps by having a third or fouth shade/color you could have more information) segments. Then, in each (...) (24 years ago, 12-Apr-01, to lugnet.robotics)
|
