Subject:
|
Re: 2.0 Firmware
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 12 Apr 2001 17:24:59 GMT
|
Viewed:
|
1022 times
|
| |
|
|
In lugnet.robotics, Ben Firshman <Ben@firshman.demon.co.uk> writes:
> In article <GBn3FD.Cw5@lugnet.com>, Dean Hystad <dean.hystad@mts.com>
> writes
> > Did you edit the ATLClient.ini file? You have to specify where ATLClient is
> > supposed to look for the files it uses (this is discussed in the Install.txt
> > file). After editing this file, run ATLClient.exe and download the new
> > firmware.
>
> What and where would the 'DLL' path be??
The DLL path is the directory that the *.dll files are located (dll standing
for Dynamic Linked Library).
You probably unzipped all the files into one directory. If this is the case
then all the paths should be to that directory. Make sure that you have a
"\" as the last character of each path.
|
|
Message has 1 Reply:
 | | Re: 2.0 Firmware
|
| In article <GBowDn.LKr@lugnet.com>, Dean Hystad <dean.hystad@mts.com> writes (...) I get the message 'Error Starting Program ----- The ATLCLIENT.EXE file is linked to missing export ATL.DLL:57' and then 'G:\Program Files\RcxCC\RCX2\ATLClient.exe (...) (24 years ago, 14-Apr-01, to lugnet.robotics)
|
Message is in Reply To:
| | Re: 2.0 Firmware
|
| In article <GBn3FD.Cw5@lugnet.com>, Dean Hystad <dean.hystad@mts.com> writes (...) What and where would the 'DLL' path be?? (24 years ago, 12-Apr-01, to lugnet.robotics)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
