 | | Re: A couple of questions
|
|
(...) Only by the vocal majority, I think. There has been a recent thread about a sub-group (cult?) of "grinders". I say the end justifies the means here. You might look into FischerTechnik (my spelling may be off). Someone on this newsgroup did (...) (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: Length of Diagonal Spreadsheet
|
|
(...) Er oops :) that's a 2L spacing, same as 24T to 8T or 16T to 16T. (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: Length of Diagonal Spreadsheet
|
|
(...) I'm assuming he's talking about the 12T double bevel gear. Three sets that I know of that have them are the DDK, the Technic 8448 Super Street Sensation and the Technic 8008 Stormtrooper. They have a standard 3L mesh spacing when used with a (...) (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: Length of Diagonal Spreadsheet
|
|
(...) For gear spacings, you might try: (URL) My testing shows that errors as great as 5% are usually no problem for (...) That *can't* be right. The tolerable error for two 40t gears is no different from the error for two 8t gears - so it's (...) (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: program wont stop running
|
|
(...) If the person stops running, then that means the program has stopped. The "Run" button stops a program and turns off the motors. However, when a program finished normally (with nothing more to do), the motors are left in whatever state the (...) (24 years ago, 8-Apr-01, to lugnet.robotics, lugnet.robotics.rcx.nqc)
|
