 | | Re: Solar cells and caps: lego part #s
|
|
(...) The capacitor is very much polarity-sensitive. It has +/- polarity indicators on either side of the standard 2x2 9V terminal, as does the solar cell, and it will not work if the polarity is reversed. (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | AI in MindStorms
|
|
I had done a project that integrated the Neural Network and Fuzzy Logic into the RCX for Navigation by legOS. Of course, the network models are simple due to the limited recources. I do not have time to manage the materials and upload them yet. But (...) (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | Re: AI in MindStorms
|
|
My entire goal is AI with mindstorms as input sensors. I'll put up a web page as soon as I have anything. Scott (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | lego cap, polarity, etc
|
|
(...) I don't have one, but can make some guesses. A bridge only works with an AC input - it can't correct the polarity of a DC input. So the Lego cap either has an AC input possibly through a bridge or a DC input which is the correct polarity by (...) (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | Re: lego cap, polarity, etc
|
|
(...) connectors. Uh, a bridge wouldn't be very good if it didn't handle inputs that switched polarities. A bridge should work just fine with a DC input of any polarity (of course for any DC input, only half of the bridge is actually being used). (...) (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | Re: lego cap, polarity, etc
|
|
(...) Right, what I was trying to say is that a bridge can't 'invert' a DC input of one polarity to make an output of another polarity - it can't "correct" anything, a diode can only conduct or not conduct. All a bridge can do is route the given DC (...) (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | Re: lego cap, polarity, etc
|
|
If I read correctly, it sounds as if there are + and - signs on the capacitor, which would imply that there is something that would block an incorrect polarity on the terminal. Maybe the diode and the 2 transistors on the board do this, I do not (...) (24 years ago, 27-Mar-01, to lugnet.robotics)
|
| |
| | RE: lego cap, polarity, etc
|
|
That's right - it only needs to protect the capacitor from wrong polarity, but does not have to compensate. Maybe the instructions simply say "if it doesn't work, rotate the connector 90 degrees". Maybe the LED gives some indication if it is (...) (24 years ago, 28-Mar-01, to lugnet.robotics)
|
| |
| | (canceled)
|
|
|
| |
| | Re: lego cap, polarity, etc
|
|
(...) The capacitor doesn't come with any instructions, at least not when purchased individually. The LED indicates when the capacitor is fully charged; when it reaches full charge, the LED begins flashing. I'm assuming at least one of the other (...) (24 years ago, 28-Mar-01, to lugnet.robotics)
|
