 | | RE: Slope Parameter in SetSensorMode
|
|
Hi, Yes, that's also how I understand the Slope Parameter. I have recently tried to use it for locating navigational beacons. The idea is this, I found that homing in on a simple constant light source was difficult unless the light source was much (...) (28 years ago, 13-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Slope Parameter in SetSensorMode
|
|
(...) has (...) sensor (...) The input would remain in whatever state it was in last. Depending on how much light it was seeing, when the flickering stopped it could be either on or off. (28 years ago, 13-Dec-98, to lugnet.robotics)
|
| |
 | | RE: Slope Parameter in SetSensorMode
|
|
Good point, a ClearSensorValue seems to have fixed this. Thanks, David -----Original Message----- From: lugnet.robotics@lugnet.com [mailto:lugnet.robot...ugnet.com] Sent: 13 December 1998 13:47 To: lego-robotics@crynwr.com Subject: Re: Slope (...) (28 years ago, 13-Dec-98, to lugnet.robotics)
|
| |
 | | Re: space shuttle technic set cost?
|
|
What was the name of the store?????? (...) (28 years ago, 13-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Slope Parameter in SetSensorMode
|
|
(...) I wrote a simple VB program to look into this, and as far as I can tell ClearSensorValue does not reset the sensor state in this mode. It will remain in whatever state it was in until you turn the RCX off. You can even stop the program and (...) (28 years ago, 13-Dec-98, to lugnet.robotics)
|