Subject:
|
RE: Slope Parameter in SetSensorMode
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 13 Dec 1998 14:33:23 GMT
|
Original-From:
|
David <DAVID@SMALLDOMAINihatespam.CH>
|
Viewed:
|
1218 times
|
| |
|
|
Good point, a ClearSensorValue seems to have fixed this.
Thanks,
David
-----Original Message-----
From: lugnet.robotics@lugnet.com
[mailto:lugnet.robotics@lugnet.com]
Sent: 13 December 1998 13:47
To: lego-robotics@crynwr.com
Subject: Re: Slope Parameter in SetSensorMode
>David wrote
>I also noticed that it has a tendency to remain true even
after the light
has
>stopped flashing, don't know if the light bulb was
flickering and the
sensor
>was responding to this.
The input would remain in whatever state it was in last.
Depending on how
much light it was seeing, when the flickering stopped it
could be either on
or off.
|
|
Message has 1 Reply:
 | | Re: Slope Parameter in SetSensorMode
|
| (...) I wrote a simple VB program to look into this, and as far as I can tell ClearSensorValue does not reset the sensor state in this mode. It will remain in whatever state it was in until you turn the RCX off. You can even stop the program and (...) (26 years ago, 13-Dec-98, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
