Subject:
|
Re: Power inlet to RCX 1.5?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 2 Jan 2001 23:36:52 GMT
|
Viewed:
|
664 times
|
| |
|
|
lego-robotics@crynwr.com (Raoul Sullivan) writes:
>
> I have a power supply that gives 9.3 volts and can give 130mA. Just 3
> questions -
>
> 2) 130mA. Is that enough? I'm not sure how the RCX works internally, but the
> motors run fine on the supply, and I assume that they are going to be the
> biggest draw on the power supply. (Assumption is the mother of all
> screw-ups)
The motors without any load don't draw much current.
I guess that 130mA is not enough if you really make them work hard.
Jürgen
--
Jürgen Stuber <stuber@loria.fr>
http://www.loria.fr/~stuber/
|
|
Message is in Reply To:
 | | Re: Power inlet to RCX 1.5?
|
| I have a power supply that gives 9.3 volts and can give 130mA. Just 3 questions - 1) Presumably the RCX can take 9.3 volts? It's not much over 9V... (Sound of frying RCX) 2) 130mA. Is that enough? I'm not sure how the RCX works internally, but the (...) (24 years ago, 2-Jan-01, to lugnet.robotics)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
