 | | Re: Help! I think I nuked my IR transmitter!
|
|
(...) When you reboot your computer, does the green light on the tower light up? If not, make sure you have your Serial ports turned on in Windows and the Bios. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (25 years ago, 1-Jan-01, to lugnet.robotics)
|
| |
| | Re: Help! I think I nuked my IR transmitter!
|
|
Usually these circuits are protected against reversed polarity. Does the green light work after the battery was properly installed. Have you succeeded in installing the firmware? Try different settings on the tower switch. Short range and Long (...) (25 years ago, 1-Jan-01, to lugnet.robotics)
|
| |
| | Re: Motor Drivers
|
|
I use the L293D in my Lego Automation Controller. PWM works fine with this chip. (I built several variations of the controller before Mindstorms was available.) - pete. (...) -- Pete Sevcik sevcik@flash.net Techno-stuff Robotics (URL) for FUN ! (25 years ago, 31-Dec-00, to lugnet.robotics)
|
| |
| | Re: Help! I think I nuked my IR transmitter!
|
|
"John Phillips" <buckwheatphillips@msn.com> wrote in message news:G6Hpxs.1uH@lugnet.com... (...) the (...) John, I think you're OK. The 9V terminals inside of the IR Tower are different sizes - one small hole, and one large one (in the plastic (...) (25 years ago, 1-Jan-01, to lugnet.robotics)
|
| |
| | Help! I think I nuked my IR transmitter!
|
|
Hello All, I'm new to all this so please forgive me if I breach any format or protocal. I'm having some trouble with downloading my Mindstrorms 1.0 RCX. Every time I try a message says IR trans. not working. I tried all the suggestions it gave and (...) (25 years ago, 1-Jan-01, to lugnet.robotics)
|
