Subject:
|
Re: "No Contact" Homebrew Train Sensor for Mindstorms
|
Newsgroups:
|
lugnet.trains, lugnet.robotics
|
Date:
|
Tue, 5 Dec 2000 19:38:11 GMT
|
Viewed:
|
47 times
|
| |
|
|
In lugnet.trains, Larry Pieniazek writes:
> Is there a photo that clearly shows the sensor in a fairly tight closeup so
> that it can be judged how obtrusive/invisible it is? I skimmed through many
> of the photos posted by you, Dave, and Tim but did not see one, although I
> may have missed it...
1) take a section of straight track.
2) take a light gray 2x4 plate and place it so that it spans the 2-stud gap
between two of the ties.
3) imagine a very thin silver piece lying on that.
That's it. Most of the people I talked to about it spent quite a while trying
to work out how the gate worked, and still didn't notice the sensor until it
was pointed out to them. You could make it even less obtrusive by making the
plate in step 2 dark grey to match the ties.
eric
|
|
Message is in Reply To:
21 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
