To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 10241
10240  |  10242
Subject: 
Re: Friction Pulley question
Newsgroups: 
lugnet.robotics
Date: 
Mon, 24 Jan 2000 03:08:45 GMT
Original-From: 
Daniel A. Segel <daniels@netcom.^NoMoreSpam^com>
Viewed: 
609 times
  
At 04:10 AM 1/24/00 +0000, Mauro Vianna wrote:
This pulley was mentioned in Dave Baun book (scanbot, page 167).
Did anybody use the friction pulley from mindstorms kit to do connect 2
axles? It has a cross hole on one end and a rubber ring in the other that
seens to fit an axle.

I have three of these pulleys, and they're all too tight to allow any
slipping at all. Maybe when they're a little older they'll function more
like you're suggesting.

Daniel Segel

--
"Ich bin ein Geleeschaumgummiring."
daniels@netcom.com



Message has 1 Reply:
  Re: Friction Pulley question
 
"Daniel A. Segel" <lego-robotics@crynwr.com> wrote in message news:4.2.0.58.200001...com.com... (...) I thought about that too. If you use if with after some gear reduction instead of attaching directly to the motor axle it may work. I'm trying to (...) (24 years ago, 24-Jan-00, to lugnet.robotics)

Message is in Reply To:
  Friction Pulley question
 
This pulley was mentioned in Dave Baun book (scanbot, page 167). Did anybody use the friction pulley from mindstorms kit to do connect 2 axles? It has a cross hole on one end and a rubber ring in the other that seens to fit an axle. It seens it (...) (24 years ago, 24-Jan-00, to lugnet.robotics)

12 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR