To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *8366 (+10)
  RE: navigation with compass
 
(...) -- Did you check the web site first?: (URL) (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Re: AC Adapter Specs?
 
(...) Look on your RCX. Any normal DC adapter between 9 and 12 Volts. ---...--- ---...--- Sam Edwards "On the keyboard of life, always keep one finger on the escape key." -- Did you check the web site first?: (URL) (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Ball gear
 
I got a ball gear with some set the other day, and it seemed like a useful part. On the set it is just a decorative "knob" thing, but i should believe it is useful for something beyond that. I cant get it to mesh properly with ordinary gears. Any (...) (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Re: AC Adapter Specs?
 
I have looked on the RCX and I've noticed it does say "9-12V ~". From what I've gathered the "~" means polarity doesn't matter. My concern is the mA rating of 9 volt adapters. Radio Shack has about 6 different types each with a unique mA rating. (...) (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Re: Ball gear
 
If it is the one I am thinking of it does not mesh well with any of the other standard gears. This part is meant to be placed in the middle of a ring with 4 ball joints sticking off the outside edge. It is used to adjust a helicopter cyclic in the (...) (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Re: Ball gear
 
(...) The "ball gear" part is used to transfer rotation momentum to a tilted axle. In the 8880 Supercar (URL) is used to make steering wheel drive. (Actually, it has 4 wheel drive, steer and suspension.) It is also used to make a tilting helicopter (...) (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Re: batteries port
 
(...) That sounds like too much voltage for the HB. I think I remember reading that the HB runs on up to 12 V max. Check the Handy Board Technical Reference. There are much better ways to run motors that require higher voltages. Try using a separate (...) (28 years ago, 24-Jan-99, to lugnet.robotics.handyboard)
 
  Re: navigation with compass
 
(...) Richard (28 years ago, 24-Jan-99, to lugnet.robotics)
 
  Re: Wirz LMD18200
 
I'm not familiar with the Wirz board, however the board I built used the regular "motor output" of the handyboard with no modification required. The trick was to use an opto-isolator to "recover" the forward and backward logic states. That was done (...) (28 years ago, 24-Jan-99, to lugnet.robotics.handyboard)
 
  Sound Sensor Mic
 
If you are having trouble finding the crystal microphone used in my sound sensor I've found the earphone from a crystal radio kit works OK. Radio Shack sells a kit like this for about $7. (28 years ago, 24-Jan-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR