Subject:
|
Re: batteries port
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 24 Jan 1999 18:11:05 GMT
|
Original-From:
|
Will Bain <WILLBAIN@CS.stopspammersUMT.EDU>
|
Viewed:
|
1119 times
|
| |
|
|
Jeremy Foo wrote:
> i am current using power supply of around 15 to 20 volts to supply to my
> HB. i remove the 9.6 batteries supply cause it does not have the
> strength to drive my 30 v dc motor.
> will it affect the board?
That sounds like too much voltage for the HB. I think I remember
reading that the HB runs on up to 12 V max. Check the Handy Board
Technical Reference. There are much better ways to run motors that
require higher voltages. Try using a separate motor power source
(requires severing a trace on the HB--see the FAQ for details).
-- Will
, ,
__@_/ \_@__ |/
| /__, o @_/
)\ ) ( \ (\/\\,
~~~~~~~~~ ' ` ~~~~~~~~~~~ ` ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Wendy Parson, When people are free to do as they please,
Will Bain, they usually imitate each other.
& Tatoosh --Eric Hoffer
|
|
Message is in Reply To:
 | | batteries port
|
| dear readers, i am current using power supply of around 15 to 20 volts to supply to my HB. i remove the 9.6 batteries supply cause it does not have the strength to drive my 30 v dc motor. will it affect the board? jass (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
