Subject:
|
batteries port
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 23 Jan 1999 19:59:19 GMT
|
Original-From:
|
Jeremy Foo <soundstruck@pacific.net.&NoMoreSpam&sg>
|
Viewed:
|
1054 times
|
| |
|
|
dear readers,
i am current using power supply of around 15 to 20 volts to supply to my
HB. i remove the 9.6 batteries supply cause it does not have the
strength to drive my 30 v dc motor.
will it affect the board?
jass
|
|
Message has 1 Reply:
 | | Re: batteries port
|
| (...) That sounds like too much voltage for the HB. I think I remember reading that the HB runs on up to 12 V max. Check the Handy Board Technical Reference. There are much better ways to run motors that require higher voltages. Try using a separate (...) (26 years ago, 24-Jan-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
