To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *7726 (+10)
  Re: Book on Robot Sensors and Navigation Techniques.
 
As long as we're on the subject of books, I'd like to recommend "Mobile Robots" by Anita Flynn and Joe Lee Jones: (URL) a fascinating book, full of hands-on information. It contains step by step instructions for building several robots, including (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Motor Ports
 
Hi all, Is it possible to add more motor ports to the handy board by simply copying the existing motor drive circuit and putting them on the expansion header where the extra chip select lines are. if so what changes would be needed to make IC (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
 
  DL problems
 
I put together the HB shortly after it first became available. This is key because it worked-downloading and all. I put it down for a year because of family problems but all that time left it plugged in because of the Ni-cad. I feel that should (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
 
  Re: Pneumatic Tanks
 
Fredrik Glöckner wrote in message ... (...) Yes, injection needles. Make sure to get a small gauge needle. Since the air is thin, you need a small restriction to see any reduction in flow. Drug stores normally have disposable needles, but you might (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: The Ten Commandments of Lego
 
What happened to Thou shalt not glue Lego? (...) -- Technical Support requests should be sent to support@opendisc.com Joe Greene Technical Support OpenDisc Systems, Inc. Boulder, Colorado, 80301-2442 USA 303-546-0460 Joe_Greene@OpenDisc.Com (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  cant control motor speed
 
dear fred and readers my motors is 30V. i am using the external batteries as instructed on the website. but i cant control the motor speed using the command: motor(0,...) i then remove the external batts and supply power to the other power pts(top (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
 
  Re: Using a standard remote control with the RCX
 
Hey Eric, You might have to send the "send RCX" command to the remote to allow it to contact the RCX. ALso, it will not be able to send confirmation to the RCX when the RCX starts with the protocol response or some such thing. (...) ---...--- (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: HB and Acceleration
 
(...) Most likely not, Max, unless I save up a lot of money and get a daVinci organizer or something like that and write up a donwlink program... :-) There's this thing here in Wisconsin (And in Michigan and Iowa) called "Rockets for Schools" It (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
 
  LEGO Robot Arena page is up
 
Hello, I've put up a page describing my upcoming Mindstorms robot fighting tournament in San Jose, California: (URL) also received some e-mail from someone who is interested in an east coast event (Sarasota, Florida). If you're on the EAST coast and (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  RE: HB and Acceleration
 
Hi Philsky; I've seen videos of some of these "serious amateur" rocket launches, and from that I would say acceleration is your prime concern, followed by shock and vibration. I'm assuming you will substitute a lightweight 9V lithium battery for the (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR