To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *7041 (-5)
  Anyone implemented wall following behavior
 
Has anyone successfully implemented wall following behavior? If so, what kind of sensors or sensor tricks did you use to maintain a constant distance from the wall. Also do you have examples of nqc code that you would be willing to share? Your help (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: legOS - Does it work for you?
 
(...) If you change the BUTTON_RUN to BUTTON_PROGRAM in the speeds function it will work properly. Although there seems to be very little difference between a speed of 1 and a speed of 7. -rick (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: voice recording and playback system
 
great website. Got a suggestion for you. Notice you are using the counter sink screws. Have looked at the brass #4 machine head screws? I am going to make some light sensors this weekend based on your design, for my project. I would think the (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: Glueing blocks
 
I've successfully created mating surfaces by using a gel superglue. To create the mating surface, create a flat surface (if one doesn't exist) with epoxy. Then spread the gel glue on the suface, put down a piece of celophane wrap. Then press a lego (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: sensor input mux calculations
 
I've thought about this, but I've come up empty. If you could get between the input line and the 10K pull-up resistor, it would be easy. You could then wire the CdS cells on either side, with a 10K resistor from one cell to ground. Then when the (...) (28 years ago, 31-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR