 | | motor command question
|
|
Why would two motors, set to turn and with unlimited chosen for time out, only turn a couple of times and stop. this motor command is the only command in the program. patty (17 years ago, 3-Dec-07, to lugnet.robotics.nxt)
|
| |
| | Re: NXT compatible bluetooth adapters
|
|
Besides, there's an according list on the official LEGO MINDSTORMS NXT site: (URL) certainly not complete, though, but a starting point (and they may be interested in the results of this discussion as well). As for BlueSoleil, I could not get it (...) (17 years ago, 3-Dec-07, to lugnet.robotics)
|
| |
| | Re: NXT compatible bluetooth adapters
|
|
I bought the Kensington 33085 and have had that working fine on 3 different PCs. I also bought a no-name bluetooth adapter that uses the BlueSoliel software. I was able to get that one working on the PCs as well. The Kensington, bought for about $50 (...) (17 years ago, 3-Dec-07, to lugnet.robotics)
|
| |
| | Re: NXT compatible bluetooth adapters
|
|
I bought one of those "no name" adapters (with Bluesoleil software) $10 (Australian). Of course, plug and no-go. Then I found this: (URL) working now. The adapter has been identified as "ISSC USB Bluetooth Device". (...) (17 years ago, 3-Dec-07, to lugnet.robotics)
|
| |
| | Re: Nxc and Mindsensors stuff
|
|
(...) Thank you! But it worked only after firmware upgrade (to version 1.05) and using original NXT flat cables (Mindsensors flat cables are very poor quality). -- alf (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
| |
| | Re: recharging NXT battery block with DC adapter?
|
|
My NXT Charger came with my battery. The output of the charger is 10.8 volts, 700 ma 8W. I would just buy the Lego charger. After reaching a full charge, the charger goes into a trickle charge mode. "Pavel Petrovic" <pavel.petrovic@gmail.com> wrote (...) (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
| |
| | Re: recharging NXT battery block with DC adapter?
|
|
(...) Whew! I was going to put my question in past tense ("Does this mean that I should have or shouldn't have used the train controller plug ...") but it seemed better to be a fool after doing something not dumb than after doing something dumb! (...) (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
| |
| | Re: recharging NXT battery block with DC adapter?
|
|
(...) You should. The NXT battery expects the same wallwart as the train controller and RCX. Philo (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
| |
| | Re: recharging NXT battery block with DC adapter?
|
|
(...) Brian, So, does this mean that I should or I shouldn't use the train controller plug thingy that I use for the trains and my RCX? Rafe (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
| |
| | Re: recharging NXT battery block with DC adapter?
|
|
(...) I'd say a bad idea, since it's supposed to be supplied with 9-12V *AC* (not DC) power. Like the RCX 1.0, it might work under a DC supply... but that's not what it was designed for. (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
