 | | Re: Date/Time Clock for NXT?
|
|
In article <J9Jv4v.nDo@lugnet.com>, Dick Swan <dickswan@sbcglobal.net> writes (...) This question seems straightforward. In the hardware schematic PDF that Lego have published there is a block diagram of the "Power Block" on page 4. This does indeed (...) (20 years ago, 30-Nov-06, to lugnet.robotics.nxt)
|
| |
 | | Re: Date/Time Clock for NXT?
|
|
Hi Dick, (...) that is all less than crystal clear from the AT91SAM7S data sheet, but plausible. (...) I think so, too. On page 2 at the left there is the circuit which generates VCC3V, and it is controlled by the AVR via P_EN. The 1.8V for the core (...) (20 years ago, 30-Nov-06, to lugnet.robotics.nxt)
|
| |
 | | Date/Time Clock for NXT?
|
|
A date/time clock would be a useful addition to the NXT. Naturally, it should continue to operate even when the NXT is powered "down". So here's a question for any hardware gurus that have a good understanding of the NXT schematic. The ARM processor (...) (20 years ago, 30-Nov-06, to lugnet.robotics.nxt)
|
| |
 | | Re: Custom sensors on the cybermaster
|
|
Hi Jerry, (...) It's not that useless, the light sensor also works passively, it's just even less sensitive than in active mode. Jürgen (20 years ago, 29-Nov-06, to lugnet.robotics.cybermaster)
|
| |
 | | Re: Custom sensors on the cybermaster
|
|
(...) Good I found this post today - I was just about to fool around w/ one of my spare cybermasters and hook up the RIS light sensors to it. So that's obviously a useless attempt, as the active sensors won't do a thing. Which in turn means that in (...) (20 years ago, 28-Nov-06, to lugnet.robotics.cybermaster)
|