 | | Re: Dual Hex small piston compressor (repost)
|
|
(...) Hi Kevin I've just been studying the pictures again and they gave rise to a few thoughts. The broken hoses, I'm assuming you mean they pop off rather than suffer fatigue cracking, so is this because the pressure generated inside can become so (...) (21 years ago, 19-Aug-05, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: container in a container error
|
|
(...) Thanks Claude. I look forward to implementing the correction. Tom (21 years ago, 17-Aug-05, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: RCX to RCX LNP
|
|
Hi. (...) That would be a fun state machine to set up... ;-) (...) It only does so when it receives opcodes between 0xf0 - 0xf7 or a standard firmware message (0x55). Of the first eight, only 0xf0 and 0xf1 currently require further action, with 0xf0 (...) (21 years ago, 17-Aug-05, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Two Usb towers
|
|
Just as a point of reference -- My latest creation has 7 motors, requiring 3 RCX's. All the high-level logic is written in Python and runs on my laptop. I communicate with the bricks through a single usb tower, using simple file I/O. The open call (...) (21 years ago, 17-Aug-05, to lugnet.robotics)
|
| |
 | | Re: Dual Hex small piston compressor (repost)
|
|
(...) While at Brickfest, Nathan shared his knowledge of radial engines with me. My future radial designs will have an odd number of evenly spaced pistons/pumps. I knew that one critical issue was that the piston shaft needs to point at the axle of (...) (21 years ago, 16-Aug-05, to lugnet.technic, lugnet.robotics)
|