 | | Re: Problems with the linux version
|
|
Hi Raphael, hi Reto, (...) Lejos 2.1.0 has been released in the meantime, it should support all this. Jürgen (23 years ago, 25-Dec-02, to lugnet.robotics)
|
| |
| | Re: RCX/Spybotics/Scout communication
|
|
(...) With the latest release of Brixcc, you have the ability to control the spybot. I sent commands to the spybot from Bricxx, but havent' gotten to the point of actually sending commands from the RCX to the Spybot--been a little busy lately. That (...) (23 years ago, 24-Dec-02, to lugnet.robotics.spybotics, lugnet.robotics.rcx, lugnet.robotics.scout)
|
| |
| | Re: RCX/Spybotics/Scout communication
|
|
(...) I'm no expert here, but I hate to see questions go unanswered. I believe you can use the same NQC commands to send messages to and from the spybot as used in the standard RCX. (23 years ago, 24-Dec-02, to lugnet.robotics.spybotics, lugnet.robotics.rcx, lugnet.robotics.scout)
|
| |
| | Re: Problems with the linux version
|
|
Interesting 3D LIDAR component: (URL) Didn't look deeply enough to determine what it could and could not be interfaced with or used for. Chris - Xenon (23 years ago, 23-Dec-02, to lugnet.robotics)
|
| |
| | RCX/Spybotics/Scout communication
|
|
Having read the messages in the various newsgoups, I must admit I'm a little puzzled. I've seen a lot of discussion about IR communication, but I don't think I have a straight answer. I have an RCX, a Scout, and some Spybotics under the Christmas (...) (23 years ago, 23-Dec-02, to lugnet.robotics.spybotics, lugnet.robotics.rcx, lugnet.robotics.scout)
|
| |
| | Re: flame sensor
|
|
(...) Oops, I guess I was wrong, then. Thanks for the correction, John. :-) ~Mike (...) (23 years ago, 23-Dec-02, to lugnet.robotics)
|
| |
| | Re: flame sensor
|
|
I know that the terms of use for lugnet prohibits advertising, but I assume it permits anti-advertising :) The item identified in this post will not act as a flame sensor. It is a proximity sensor which works by emitting its own IR illumination (...) (23 years ago, 23-Dec-02, to lugnet.robotics)
|
| |
| | Re: flame sensor
|
|
(...) Vincent, I think I know of something that will fit what you want exactly. John Barnes ((URL) makes an InfraRed sensor that supposedly works over a range of 1-7 inches. Sensor info here: (URL) that helps, ~Mike (23 years ago, 23-Dec-02, to lugnet.robotics)
|
| |
| | Re: flame sensor
|
|
I know folks use this sensor for the trinity fire fighting contest.... (URL) (23 years ago, 23-Dec-02, to lugnet.robotics)
|
| |
| | unique Identifer in RCX
|
|
Is there a unique identifier hard coded into the RCX? I recall reading somewhere that the serial number printed on the side of the RCX could be called up using NQC or LegOS. I may be wrong I would like to use this number for data logging so I would (...) (23 years ago, 23-Dec-02, to lugnet.robotics)
|
