 | | Re: Announcing LegWay, Finally
|
|
(...) Thanks. Most of my robots are more about function than form, but I also think it's important to have a good bridge crew... (URL) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | RE: Announcing LegWay, Finally
|
|
Hi people, about inclined surfaces, will the LegWay works with four light sensors? C (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | Re: Announcing LegWay, Finally
|
|
(...) Thanks (...) hmm. no. A couple people have asked this question. Actually, I've put it on a table, and lifted one side of the table. LegWay will tilt, to correct for the angle. (while it rolls down the hill!) It constantly checks the distance (...) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | RE: Announcing LegWay, Finally
|
|
As everyone can see, I think my brain stopped working this past few minutes :> Ok. Now that I got my brain working again (I hope) let's give another go at this. LegWay and an inclined surface: The LegWay will try to climb up to the point where the (...) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | Re: Announcing LegWay, Finally
|
|
(...) I think it's absolutely fabulous! A clever solution to the tricky task of top-heavy balancing...for that really is the essence of it. I like the simple approach involving very few parts. Well done! BTW, in looking at your website I noticed (...) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | RE: Announcing LegWay, Finally
|
|
OOPS.... SORRY for the "duplicate" msg! :/ I forgot I was using the lego-robotics@crynwr.com instead of the "need confirmation before posting" lugnet.robotics news list. Sorry. mc. (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | RE: Announcing LegWay, Finally
|
|
(...) Congrats for making *THE* LegWay :) ...a much talked theoretically possible project, but you done it :) Question: Your solution only works on perfectly horizontal surfaces, right ? What happens if you put a inclined surface in front of the (...) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | RE: Announcing LegWay, Finally
|
|
(...) Congrats for making *THE* LegWay :) ...a much talked theoretically possible project, but you done it :) Question: Your solution only works on perfectly horizontal surfaces, right ? What happens if you put a inclined surface in front of the (...) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | Re: Announcing LegWay, Finally
|
|
(...) sites, so the bandwidth should be ok for a few hours! Here's one of the mirror sites: (URL) have the LegWay remote working, but it's a bit rough. I didn't realize LegWay could go from a full-speed spin to a dead stop without falling over. Now, (...) (23 years ago, 17-Oct-02, to lugnet.robotics)
|
| |
| | Problems with SDL-Programming and legos
|
|
I have assume an existing SDL-System with an env.c-File. I tried to change this system to communicate between two RCX. Now my problem: In the case that i have one RCX who only send and one who receive, it works. But if i try the create a (...) (23 years ago, 17-Oct-02, to lugnet.robotics.rcx.legos)
|
