 | | Re: Quick reference for NQC?
|
|
This may not help, but try BricX. I believe it comes with NQC built in, along with a nice little GUI. The firmware is the same as what came with your lego software. I don't know about you, but I was pretty much able to learn how by looking at the (...) (23 years ago, 10-Oct-02, to lugnet.robotics)
|
| |
| | Quick reference for NQC?
|
|
Where would I find a simple reference for getting started with NQC? I'm looking for something that lists what software/firmware you need to get NQC code into the RCX and walks you through getting a program running. Thanks! -- Tony Hafner (...) (23 years ago, 10-Oct-02, to lugnet.robotics)
|
| |
| | Re: Adapting mini-rc reciever to an RCX sensor
|
|
(...) Most toy and model R/C interfaces use pulse-width modulation. You could simply send that data stream into the RCX which would take a fair amount of software decoding (I doubt you could do it with the Lego Firmware - you'd C and LegOS or (...) (23 years ago, 9-Oct-02, to lugnet.robotics)
|
| |
| | Re: Gcc Problems
|
|
Rick, It sounds as if you have gcc working, however, the version of objcopy that you copied from another folder is incompatible with the hitachi h8 version of gcc. You need to have a special version of objcopy that is designed for the h8 (the RCX). (...) (23 years ago, 9-Oct-02, to lugnet.robotics.rcx.legos)
|
| |
| | Gcc Problems
|
|
Hello, There is a line under Hitachi H8 tool prefix that goes like this: HMSTOOLDIR=/usr/local/crossgcc. I changed it to HMSTOOLDIR=/usr/local and I changed TOOLPREFIX=$(HMSTOOL...tachi-hms- to TOOLPREFIX=$(HMSTOOL...i-hms/bin. After looking through (...) (23 years ago, 9-Oct-02, to lugnet.robotics.rcx.legos)
|
