 | | Re: Intimidated by LEGO Minstorms -- was: Service pack 5111 - Wires - no longer available
|
|
(...) I think the remote controller is an absolute *must* for the serious robotics builder - I *love* mine. * It allows you to decouple the programming task from the mechanical design task. While you are building, you can check that everything is (...) (24 years ago, 4-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Intimidated by LEGO Minstorms -- was: Service pack 5111 - Wires - no longer available
|
|
I agree that building things in Lego from a well organised set of parts bins is a *TOTALLY* different experience from rummaging around in a large box of unsorted parts. I'm completely sold on it. However, I don't think that's obvious to most parents (...) (24 years ago, 4-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Use RCX motor output to switch devices
|
|
(...) This appears to be a PNP transistor according to this datasheet: (URL) transistor in the circuit diagram I provided is NPN. Also, the maximum current the BC557 can handle is only 100ma (I think you needed 250ma or so). In other words, this (...) (24 years ago, 3-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Loading firmware
|
|
(...) Bruce (24 years ago, 3-Sep-02, to lugnet.robotics.rcx.pbforth)
|
| |
 | | Re: Over Charging
|
|
When the batteries are really run down, they can draw too much current through the on-board charging circuit. (I'm assuming you are plugging adapters directly to the HBs, rather than going through the serial interface/phone line charge ckt.) About 6 (...) (24 years ago, 3-Sep-02, to lugnet.robotics.handyboard)
|