To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *34139 (-10)
  Re: Brainstorms
 
Steve, Thanks for the quick feed back : ) Please take a look below ... & LMKWYT. -JSM Steve Baker <lego-robotics@crynwr.com> wrote in message news:3D56C75C.403000...ail.net... (...) I was thinking that it could be used to hook up to joysticks, (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Brainstorms
 
(...) What you want... surely must depend on what you can reasonably expect to get. I have no expectation that LEGO will come up with a major revision that has the breadth and depth of the wonderful suggestions in the responses to John's post. (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Brainstorms
 
(...) Are you sure? I thought Philips had teeny-tiny microprocessors with I2C at least 10 years ago...before the I2C bus switched speeds from 100kbps to 400kbps. I2C is about 20 years old. (...) Address pins? What address pins? ---...--- Steve Baker (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Brainstorms
 
(...) The RoboBricks project was started 2-1/2 years ago. At that time, there were no readily available and 8-pin microcontrollers with built in I2C support. The Atmel tinyAVR series had some I2C support, but the chips were extremely difficult to (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Brainstorms
 
(...) So I imagine the need for a brainstorm brick that has a standard Lego wire connection on the top and a little I2C chip inside that would interface with existing motors and sensors. This would certainly be needed because nobody wants to butcher (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Brainstorms
 
OK, I've been watching this thread for a few days (I am LUCNY's "Expert Lurker" after all !) and refining some ideas that I've had for a while in hopes that I can contibute to this dicussion in a useful way. Please keep in mind that I'm a Mechanical (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  About lejos 2.0!
 
Hi! Does lejos 2.0 need Java Comm. API? Laurence (24 years ago, 11-Aug-02, to lugnet.robotics.rcx.robolab)
 
  Re: Brainstorms
 
(...) <snipped some reasonable arguments> This is why I recommend that 'brainstorms' goes with something like I2C. That protocol is fast and built into the chip. No software serial I/O is ever needed and every chip already speaks the protocol so (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Brainstorms
 
Steve: Everything is a compromise. Here is a discussion of the issues that caused us to pick 2400 baud for RoboBricks: 1) Most of the various PIC's that we use (PIC12C509A, PIC12C672, PIC16C505) run at 4MHz. The 4MHz clock rate is divided by 4 to (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
 
  Re: Spybotics vs Cricket
 
Paul Andrews writes: > In lugnet.robotics, Russell Nelson <nelson@crynwr.com> writes: > *Mad* props to anybody who > >makes a loop network (ala the Clarkson Loop from my Master's thesis) > >out of three or more spybots. > > Err. What's a Clarkson (...) (24 years ago, 11-Aug-02, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR