 | | Re: Brainstorms
|
|
OK, I've been watching this thread for a few days (I am LUCNY's "Expert Lurker" after all !) and refining some ideas that I've had for a while in hopes that I can contibute to this dicussion in a useful way. Please keep in mind that I'm a Mechanical (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
|
| |
 | | About lejos 2.0!
|
|
Hi! Does lejos 2.0 need Java Comm. API? Laurence (24 years ago, 11-Aug-02, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: Brainstorms
|
|
(...) <snipped some reasonable arguments> This is why I recommend that 'brainstorms' goes with something like I2C. That protocol is fast and built into the chip. No software serial I/O is ever needed and every chip already speaks the protocol so (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
|
| |
 | | Re: Brainstorms
|
|
Steve: Everything is a compromise. Here is a discussion of the issues that caused us to pick 2400 baud for RoboBricks: 1) Most of the various PIC's that we use (PIC12C509A, PIC12C672, PIC16C505) run at 4MHz. The 4MHz clock rate is divided by 4 to (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
|
| |
 | | Re: Spybotics vs Cricket
|
|
Paul Andrews writes: > In lugnet.robotics, Russell Nelson <nelson@crynwr.com> writes: > *Mad* props to anybody who > >makes a loop network (ala the Clarkson Loop from my Master's thesis) > >out of three or more spybots. > > Err. What's a Clarkson (...) (24 years ago, 11-Aug-02, to lugnet.robotics)
|
| |
 | | RE: Programming multiple controllers
|
|
(...) OK, I'll bite, how does the Spybot get into this state? We've already discussed how to set up a secure link - how do we set up a non-secure link? Cheers, Ralph (24 years ago, 10-Aug-02, to lugnet.robotics.spybotics)
|
| |
 | | Re: Programming multiple controllers
|
|
(...) got (...) configuration? Bot one must be on Accept commands from ALL channels Mode. Dean (24 years ago, 10-Aug-02, to lugnet.robotics.spybotics)
|
| |
 | | Win98 install help
|
|
Hi there. Please can someone help me. I've been following the instructions at: (URL) word for word and then I got to the bit where it says: "Last setup I've tried let you choose which modules you need to download and setup. Here is a minimal list (...) (24 years ago, 10-Aug-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: measuring motor voltage on sensor input
|
|
Quoting Paul Andrews <paul@jools.net>: (...) How about a simple resistive divider across the motor output, say two 1 Kohm resistors, with the motor on the top of the two and the sensor input on the midpoint, so it sees the battery divided by two? (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | RE: Brainstorms
|
|
(...) <just an opinion> The 2400 baud rate was probably chosen as a compromise between speed and what could reasonably be done on the teeny leetle PIC processor that drive the bricks. In practice, with the dedicated protocol that Wayne describes, (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|