 | | Re: Shaft Encoders
|
| (...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (29 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | |  | | Re: Shaft encoder
|
| (...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (29 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | |  | | Handy board troubles.
|
| I have various handyboard and i never use the IR ports. So i'm assembling one handy, and don't put al the components asociated to that ports. I download anyprogram to that's board and never boot again!!!! The transmision is o.k. but don't start (...) (29 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | |  | | Re: Config Register error
|
| I had the same problem. I was never able to get HBDL to set the config register. I used DL to set it on one board and DLM on another. I used the information from the HandyBoard technical reference manual to use these programs. (URL) the config (...) (29 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | |  | | Config Register error
|
| hello all, I have only started building the Handy Board and have run into some problems at the very start when i first conected the part built board. I have build it as far as the power supply, stop switch and 68hc11 installed, memory and lcd. When (...) (29 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| |