Subject:
|
Config Register error
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 16 Jan 1998 05:10:12 GMT
|
Original-From:
|
Brennan Mair <Gysmo@es!avoidspam!.co.nz>
|
Viewed:
|
1880 times
|
| |
| |
hello all,
I have only started building the Handy Board and have run into some
problems at the very start when i first conected the part built board. I
have build it as far as the power supply, stop switch and 68hc11 installed,
memory and
lcd. When I try to send pcode_hb.s19 it sometimes stops half way through
and says
"error loading byte #0x98" and sometimes #0x99, #0x9a. And when it does
load it all it comes up with "invalid CONFIG Register (0x0d) try again"
although it is set to 0x0c in the box in HBDL . I have downloaded the pcode
file again from the handy board site to see if it was the file but when I
downloaded it to the board I still had no luck.
Thanks,
Gysmo@es.co.nz
|
|
Message has 1 Reply: | | Re: Config Register error
|
| I had the same problem. I was never able to get HBDL to set the config register. I used DL to set it on one board and DLM on another. I used the information from the HandyBoard technical reference manual to use these programs. (URL) the config (...) (27 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|