To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *28849 (-20)
  my Polaroid again!
 
I have checked this link regarding the interface of the Polaroid ranging system to the HB. (URL) I don’t get is the term “To Handy Board Motor Power Connector” on the connection schematic…what is actually meant by that; is it to the four motors (...) (25 years ago, 18-Jun-01, to lugnet.robotics.handyboard)
 
  E-mail authentication during posting
 
The Quick Summary ===...=== Effectively immediately, all LUGNET News posts now require e-mail authentication after posting, in order to prevent the continuance of forged messages. An exception to this rule is if you are a member and signed-in (...) (25 years ago, 18-Jun-01, to lugnet.announce, lugnet.admin.nntp, lugnet.general, lugnet.lego.direct, lugnet.robotics, lugnet.robotics.handyboard, lugnet.cad) !! 
 
  Re: Custom Firmware, IR Problems, and Dead RCXs (long)
 
(...) If you are interested I put together a simple device that allows the tower and RCX to communicate (wires now but I hope to do wireless). I used Radio Shack IR lights and receivers –catalog numbers 276-145A and 276-143C, as well as a couple of (...) (25 years ago, 18-Jun-01, to lugnet.robotics)
 
  Re: Rotation Sensor
 
Which command are you refering to? "Wait for Rotation" is positive-only I think, whereas "Angle Sensor Fork" and "Angle Container" can both deal with negatives. To make a "wait for" out of a fork, you would put a Jump in the branch of the fork that (...) (25 years ago, 17-Jun-01, to lugnet.robotics.rcx.robolab)
 
  RCX Controlled Mobile Decoupler and Train Marshling Station
 
I have two avi files that are taken by LEGOCAM, but the files are too big (20M and 25M), Does anyone know if there are any freeware for editing avi file? I hope I can edit those big files. (...) (25 years ago, 17-Jun-01, to lugnet.robotics.rcx, lugnet.robotics.scout)
 
  Re: Steering mechanism
 
Forwarding this to the list... -----Original Message----- From: Simon Bogaert Simon.Bogaert@advalvas.be Sent: Sat, 16 Jun 2001 14:47:45 +0200 To: Legomaster@gobi.com Subject: Re: Steering mechanism (...) Here's an attempt ot an ASCII-art: _ _ | | | (...) (25 years ago, 16-Jun-01, to lugnet.robotics)
 
  Rotation Sensor
 
I am very new to Robolab. I have version 2.0 and I am wondering if the rotation sensor can be programmed to react to a negative number? It seems to ignore the negative sign and react to it as a positive. -- Bob Fay rfay@we.mediaone.net (URL) (25 years ago, 16-Jun-01, to lugnet.robotics.rcx.robolab)
 
  Re: Steering mechanism
 
Hmmm. Interesting, I'm not sure, I'm trying to visualize the set up. (...) (25 years ago, 16-Jun-01, to lugnet.robotics)
 
  Steering mechanism
 
Hello all, I was building a steering mechanism with propulsion the other day, and I ran into a problem. Unknowingly, I made an Ackermann steering linkage, a setup in which the bar between the pivoting wheelsupports is shorter than the distance (...) (25 years ago, 16-Jun-01, to lugnet.robotics)
 
  RoboLab 2.x?
 
Is anyone aware of any planned or potential updates for RoboLab 2.0. It's a great piece of software but I feel that it could be so much more. Thanks, Ed Cox (25 years ago, 16-Jun-01, to lugnet.robotics.rcx.robolab)
 
  Re: Vision Command
 
Hi Alan, Have you tried using Virtual PC 4? I heard it supports USB devices like cameras, so MAYBE you could use the Lego SW from within VPC... Well, it's just a thought, but it might be worth a try (I would try it if I had a VC). (...) (25 years ago, 16-Jun-01, to lugnet.robotics)
 
  Re: Lego Mindstorms Controlled Train Crossing (Duel Track)
 
(...) That's what mine does. If any sensor is broken it starts a timer. If no sensors are broken after the timer expires they go up. This worked very well except for very short trains. Hence the plans for a third sensor right near the track to take (...) (25 years ago, 15-Jun-01, to lugnet.robotics)
 
  Re: Lego Mindstorms Controlled Train Crossing (Duel Track)
 
(...) I'm a programmer - and I have an evil mind... The train driver spots a JarJar Binks minifig standing at the crossing and with murderous intent he trundles swiftly past X1, X2 and X3 - and then stops...just far enough along to block X4 - but (...) (25 years ago, 15-Jun-01, to lugnet.robotics)
 
  Re: Lego Mindstorms Controlled Train Crossing (Duel Track)
 
(...) similar, but used 4 light sensors, 2 in parallel like this: Crossing -> | | ===...=== <- Track X1 X2| |X3 X4 X2 & X3 are in parallel, when X1 is broken, boom goes down & stays down while either X1, X2 or X3 is broken. Similarly for X4. This (...) (25 years ago, 15-Jun-01, to lugnet.robotics, lugnet.trains)
 
  Re: Lego Mindstorms Controlled Train Crossing (Duel Track)
 
Benjamin Medinets wrote in message ... (...) Dean's works beautifully, very reliable (ran for an entire show day without the slightest hitch once he had it set up). Kevin ---...--- Craftsman Lego Kits & Custom models: (URL) Lego parts store: (URL) (...) (25 years ago, 15-Jun-01, to lugnet.robotics, lugnet.trains)
 
  Re: Lego Mindstorms Controlled Train Crossing (Duel Track)
 
(...) controlled crossings in the near future...just haven't got a chance to get any Mindstorm sets... I think my inspiration came from the old classic 12 Volt level crossing with its own motorized lift gates and lights....you can still get this but (...) (25 years ago, 15-Jun-01, to lugnet.robotics, lugnet.trains)
 
  Lego Mindstorms Controlled Train Crossing (Duel Track)
 
After 9 months I finally put together the Web Page for my Lego Mindstorms Controlled Train Crossing. I invite you to check it out. (URL) Lego Workshop: (URL) Lego Club: (URL) (25 years ago, 14-Jun-01, to lugnet.robotics, lugnet.trains)
 
  Liblnp bug found and squashed ?
 
This is no good: I'm beginning to talk to myself ;] This is a follow-up on my previous post, and (hopefully) an answer to problem number 3. 'Bit technical I'm afraid. I'M STILL STUCK ON THE OTHER PROBLEMS (as of tonight anyway it's 23:48 and I'm at (...) (25 years ago, 14-Jun-01, to lugnet.robotics.rcx.legos)
 
  Re: Dual Vision Command Controll
 
Please do, cause the dual "binocular vision" is somthing I'm looking foward too plus the ability of the Robot completely interact with the two VC Cams is really neat. Good Luck!! Eric (...) (25 years ago, 14-Jun-01, to lugnet.robotics.vc)
 
  Re: Dual Vision Command Controll
 
Yeah, I was lucky enough last Christmas to confuse my wife enough to get me the Lego Movie Studio set and the Vision Command set. Since my laptop only has one USB port I had to wait until I got a USB hub before I could connect both cameras. So far I (...) (25 years ago, 14-Jun-01, to lugnet.robotics.vc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR