 | | Re: timeout on serial
|
|
Try using the 6811 Downloader MCL PPC program to do the download. It's in the software/utils page. Fred In your message you said: (...) HB (...) ". (...) (26 years ago, 4-Dec-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: motorized points - finally got it!
|
|
Yippy I finally got it! I have created a motorized switch track that ran 100 switches via RCX without tearing the housing apart or missing firing! After 100 I got tired of counting and I just stopped it, so it might go for several hundred. It sits (...) (26 years ago, 4-Dec-00, to lugnet.trains, lugnet.robotics)
|
| |
 | | timeout on serial
|
|
I am trying to download IC to handyboard. I have G4 and I am using serial to USB converter. Every time I put the board in download mode and hit "IC board HB 7.2 modem" I get an error "Timeout on serial receive. 256 chars left to receive. Perhaps the (...) (26 years ago, 4-Dec-00, to lugnet.robotics.handyboard)
|
| |
 | | printf question
|
|
I am having a problem with this line: printf("\\n"); It is print some strange ASCII character that looks like an upside down broom and I need it to print just a "\" (minus the parenths of course). I have also tried this: int d; d=92; printf("%c",d); (...) (26 years ago, 4-Dec-00, to lugnet.robotics.handyboard)
|
| |
 | | Makefile change
|
|
I recommend the following change to Makefile (in the main legOS directory: old: SUBDIRS=util lib boot demo new: include makefile.common ifneq (,$(findstring $(OSTYPE),MSDOS msdosdjgpp MS-DOS)) SUBDIRS=lib boot demo else SUBDIRS=util lib boot demo (...) (26 years ago, 3-Dec-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: difference of generated code robolab<->NQC
|
|
(...) They both generate the same "kind" of code (specifically LASM bytecodes), but its unlikely that code would be identical. I'm sure there are certain patterns of code that are typical from Robolab programs, and certain patterns that are typical (...) (26 years ago, 3-Dec-00, to lugnet.robotics)
|
| |
 | | Re: variable conversion in legOS
|
|
(...) This should work. Are you having problems with it? -Kekoa (26 years ago, 3-Dec-00, to lugnet.robotics)
|
| |
 | | Re: Communication between NQC and VisualBasic
|
|
(URL) is my scanner source code made by NQC and Visual Basic In this case, i used StartTask(), StopTask(), SetVar(), Poll(), etc. from the LEGO's control. (26 years ago, 3-Dec-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | variable conversion in legOS
|
|
Could we convert a "float" variable in legOS to "int"? Thanks Yiu (26 years ago, 3-Dec-00, to lugnet.robotics)
|
| |
 | | Re: motorized points - beating a dead horse
|
|
(...) I made a design that used a clutch gear and fit into a house. It worked very well when the switch was "warm" but wouldn't always trip it when it had been sitting for a bit. But it allowed the throw arm to fully though the switch one way or the (...) (26 years ago, 3-Dec-00, to lugnet.trains, lugnet.robotics)
|