To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *24644 (-10)
  Re: Radio Controlled Tank - tread lightly.
 
(...) Yes, please! :) Have to check if they sell Funrise brand toys here in Sweden. //Harri Manni -"Do not take life too seriously.You will never get out alive." (26 years ago, 3-Nov-00, to lugnet.robotics)
 
  Re: MOC: Radio Controlled Tank.
 
(...) Here's an idea you can try to have them slip a bit less. Do you have the ordinary chain links too? Then ones without the wide tread? If so use an ordinary chain link for every third link, say. Like this: ##=##=##=##= Perhaps this will give (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
 
  Re: MOC: Radio Controlled Tank.
 
(...) Thanks :) (...) Yes, they sure were. One of 'em I even managed to scare twice, first when the tank entered the room and then when it actually fired a projectile :) To bad it takes almost half a minute to set the cannon horisontally, I have to (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
 
  Re: MOC: Radio Controlled Tank.
 
(...) Thanks! So do I :) (...) It's from before my dark ages, mainly the 8851 Excavator and the 8660 Arctic Rescue, I also got two with the 8843 Fork Lift truck. They usually look better then they work since they tend to slip a lot, but in this case (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
 
  Re: Palm Hardware Interface idea? + other stuff
 
(...) It's basically the same serial data connection as the RCX. It just uses radio for transmission instead of infrared, so it goes around corners and has a longer range. Jürgen (26 years ago, 3-Nov-00, to lugnet.robotics)
 
  Programmable RCX display
 
One of the missing "nice-to-have" features with the RCX is a programmable display. It would be great if LEGO implemented this feature. One way could be to attach a number 0 - 6 for each segment of the four 7-segment numbers and set a corresponding (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.nqc)
 
  Re: RCX 2
 
(...) You can start by doing some searches on this newsgroup for the 3 or so discussions on this very topic. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 3-Nov-00, to lugnet.robotics)
 
  Re: Still JAVA and LNP....
 
(...) There is no way to passively listen to the world. This is good for batteries but bad in all other ways. So, your listening code should send a keep-alive on a regular basis to keep the tower from dying. No way around it :| Luis ---...--- "It's (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.legos)
 
  Re: How2 'count' in NQC
 
(...) The sensor returns 1 for as long as it's held down. In your code: (...) You are actually counting how long the switch is held down - in units of about a half second. So if you press and hold the switch for ten seconds, you'll get a count of (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
 
  Re: RCX2
 
(...) Right now, it's just a different firmware package that you can download into any RCX. You can get a copy on the main Lego site and upgrade your RCX 1.0 or 1.5 to the 2.0 software level...it's a significant improvement if you use NQC - it adds (...) (26 years ago, 3-Nov-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR