To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2436 (+5)
  RE: Corrupted or Invalid Pcode?
 
I've discovered the problem. When I mounted the Handyboard, I used metal standoffs. When the board is mounted, it doesn't work. When it isn't, it does. The solution then I guess is to use nylon washers to isolate the Handyboard from the standoffs. (...) (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  Re: Corrupted or Invalid Pcode?
 
James, Thanks for following up. The reason for this behavior should be fairly evident -- there are traces very close to the mounting screw holes. Your metal washers must have shorted them together, affecting wires to the memory. I do mention to use (...) (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  Pulse outputs??
 
I need help on understanding the motor controller circuit. Looking at the source in the lib_hb librariy it looks like different pulse trains are sent out to increase the average output voltage by poking increasing values of 256 into the rught (...) (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  enable_cheesy_encoders
 
I've tried the enable_cheesy_encoders and it doesn't seem to work for me either. What I get is 0 for the portX_shaft_count all the time. Is this what you're getting? I've looked at the code but I couldn't see why it wouldn't work. Were you or anyone (...) (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  rug warrior board
 
I am trying to wire up a rug warrior board, and i think i have thecomputational hardware all set up correctly. I have been over my wiring as best as i can and cant fina a problem. Here is what it is doing. I can download the p code interperter ok, (...) (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR