 | | Re: HB and ICC11..
|
| (...) The trick is to copy the mode-change/LCD code into the on-chip RAM and execute it from there. This code must change to single-chip mode, write to the LCD, then change back to expanded mode. When in single-chip mode, you lose access to any (...) (29 years ago, 2-Jul-97, to lugnet.robotics.handyboard)
| | |  | | Re: HB and ICC11..
|
| Hi Dale, For this to work a couple of things have to be true, first the Start_LCD, Stop_LCD, and putlcdchar() functions have to be located in the 256 bytes of on-board RAM (or in the 512byte EEPROM) The second thing is that your putchar_LCD doesn't (...) (29 years ago, 2-Jul-97, to lugnet.robotics.handyboard)
| | |  | | HB Questions??
|
| I have a few questions about the HB that I hope somebody can help me with. I'm kind of new to it and I think a few answers to some simple questions could save a lot of time. 1. The pulse modulation of the motor outputs. Is the CPU tied up (...) (29 years ago, 2-Jul-97, to lugnet.robotics.handyboard)
| | |  | | HB and ICC11..
|
| Hi, I am using ImageCraft ICC11 compiler with the Handy Board in order to produce rommable code. I was wondering if anyone has an LCD driver for the hitachi LM052L LCD used on the Handy Board. I have tried using the following code I obtained from (...) (29 years ago, 2-Jul-97, to lugnet.robotics.handyboard)
| | |  | | Trouble shooting 7.2.2 (The digital inputs)
|
| I have had no problems assembling the handy board up until now. During the testing of the digital inputs, I am not getting the proper responses. I am getting the press start button message and can successfully move on from there. I can also move on (...) (29 years ago, 2-Jul-97, to lugnet.robotics.handyboard)
| |