 | | light sensor LED control
|
|
I'm using NQC 2.2 (but I also had the problem with 2.1) to compile programs for my RCX. I don't see how to control whether the LED in the light sensor is on or off. Doing a SetSensor didn't do it...I had to run an old program from Gordon's Brick (...) (26 years ago, 4-Aug-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Vector 2x and expansion board
|
|
Hi all, I am ready to connect my vector 2x to the handy board/expansion board. I have already installed the sonar. In reading all of the past posts, no clear answer seems to be present regarding how to get the thing working IN THIS CONFIGURATION. (...) (26 years ago, 4-Aug-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: Autonomous Robot
|
|
(...) The proposed solution in the "Robot Tracking" thread sounds like it's exactly what's needed here. From the original post... (...) track the robot throughout a 20 ft x 20 ft room at a 1 Hz rate with an accuracy of 1-2 inches. In principle, the (...) (26 years ago, 4-Aug-00, to lugnet.robotics)
|
| |
 | | Re: cybermaster
|
|
You could write a routine that instead of caputing 1 pixel, captures that pixel, and the other 8 around it at once. Then you can see if the value of the pixels change from one to the other signifigantly. 011 011 011 In this simple example, you would (...) (26 years ago, 3-Aug-00, to lugnet.robotics)
|
| |
 | | Desperate need for help with lnpd
|
|
Hi! I have mentioned before in this forum that I and two friends are working on a six legged robot which is supposed to learn to walk using genetic algorithms. We are now nearly finished and yesterday we finally managed to program an IR protocol (...) (26 years ago, 3-Aug-00, to lugnet.robotics.rcx.legos)
|