 | | Re: Soldering
|
| (...) experience >at all with soldering. (...) become more >adept at this sort of stuff. And what type of solder should I use? Shane is right, you'll find using very thin solder works much better. Along with a fine tip, you'll want to use a low (...) (30 years ago, 18-May-97, to lugnet.robotics.handyboard)
| | |  | | Soldering/ Second processor
|
| ->Hi, I'm planning to purchase the handyboard as a kit from Digital Mirco System, since I'm a bit tight with money. However, I'm a bit hesitant (...) soldering. The trick is to use THIN 60/40 solder with flux core. Around 0.71 mm thickness is good. (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
| | |  | | Re: Vector 2x giving me lots of trouble...
|
| Well, I seemed to have narrowed down the problem I was having with the Vector2x compass. It was functioning fine... All I had to do was write clean code that called comp_disable(1) at the end. When my code wasn't doing that, the compass IRQ routines (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
| | |  | | '97 Intel ISEF
|
| This last week was the 1997 Intel International Science and Engineering Fair (ISEF), held in Louisville, Kentucky. While I don't have a list of winners/losers, I do have some things to say about it. There were five robots in the engineering (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
| | |  | | (no subject)
|
| Hi, I'm planning to purchase the handyboard as a kit from Digital Mirco System, since I'm a bit tight with money. However, I'm a bit hesitant about assembling the kit because I have no experience at all with soldering. Can anyone recommend something (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
| |