To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2156 (+5)
  Re: Polaroid software driver
 
---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the Advancement of Science and Art ---...--- (...) (30 years ago, 16-May-97, to lugnet.robotics.handyboard)
 
  (no subject)
 
Hi, I'm planning to purchase the handyboard as a kit from Digital Mirco System, since I'm a bit tight with money. However, I'm a bit hesitant about assembling the kit because I have no experience at all with soldering. Can anyone recommend something (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
 
  '97 Intel ISEF
 
This last week was the 1997 Intel International Science and Engineering Fair (ISEF), held in Louisville, Kentucky. While I don't have a list of winners/losers, I do have some things to say about it. There were five robots in the engineering (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
 
  Re: Vector 2x giving me lots of trouble...
 
Well, I seemed to have narrowed down the problem I was having with the Vector2x compass. It was functioning fine... All I had to do was write clean code that called comp_disable(1) at the end. When my code wasn't doing that, the compass IRQ routines (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)
 
  Soldering/ Second processor
 
->Hi, I'm planning to purchase the handyboard as a kit from Digital Mirco System, since I'm a bit tight with money. However, I'm a bit hesitant (...) soldering. The trick is to use THIN 60/40 solder with flux core. Around 0.71 mm thickness is good. (...) (30 years ago, 17-May-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR